How to wire CIMON-PLC WG02(A,C,D,E) WG04A and Loadcell
2015.11.23

Q. How to wire CIMON-PLC WG02(A,C,D,E) WG04A and Load cell


 


 


A. Refer to the instructions below.


 


 


[CIMON Load Cell Modules]


 



 


 


 


[Wiring diagram]


 



 


 


Load Cell Pin Assignment (Also for the 4 Channel)


 


 
































Number 


Name 


Remarks 


1 


SEN+ 


Sensor Line+ 


2 


SEN- 


Sensor Line- 


3 


SIG+ 


Measurement Line+ 


4 


SIG- 


Measurement Line- 


5 


EXC+ 


Supply+ 


6 


EXC- 


Supply- 


 


 


 


 


The upper most pin of each channel connector of the load cell module is number 1.


For the 6-wired load cell, connect to the lines corresponding to the wiring diagram as above. 


 


The 4-wired load cell does NOT have SEN+ and SEN- lines. 


For the 4-wired load cell, after wiring the 4 lines except SEN+ and SEN-, please SHORT CIRCUIT the SEN+ <-> EXC+ and SEN- <-> EXC- pins.


 


 


 


 [Load cell line color by manufacturers]


 


 



































































Manufacturer 


1 


EXC+ 


2 


EXC- 


3 


SIG+ 


4 


SIG- 


5 


SHIELD 


Bongshin, CAS 


Fine, DACELL 


Red 


White 


Green 


Blue 


Yellow 


(Outer Cover) 


Daesung 


KMTL 


Red 


Black 


White 


Green 


Outer Cover 


Power MNC 


Red 


White 


Green 


White 


Outer Cover 


Daisocell 


Red 


Blue 


Green 


White 


Black 


BLH 


Green 


Black 


White 


Red 


Yellow 


INTERFACE 


KYOWA 


P.T 


SHINKOH 


Red 


Black 


Green 


White 


Outer Cover 


SHOWA 


TEAC 


Red 


Blue 


White 


Black 


Yellow 


(Outer Cover) 


HUNTLEIGH 


Green 


Black 


Red 


White 


Outer Cover 


 


 


 


 


*The wiring line colors can be different for each manufacturer and their load cell models, please refer to the data sheet of the load cell in use.